Photo of the passenger side rear fenderwell...the inner edge of the fender is "lined" with 3x3 steel angle...the rear upright support is a 2x2 square tube, part of my custom body design. The "outriggers" are welded onto the 3x3 and bolted up thru the outer bars on the cage.

Another shot of the passenter rear...this one shows the 3x3 steel angling down towards the body crossmember....my crossmember is a 2x4 steel tube, part of the custom body design.

Photo showing the front hoops and the pre-stressed center bar. Has a welded in "bitch bar" for the passenger. The front hoop was custom bent to closely match the dash...the bottom foot plate of the front hoop aligns directly over the factory body mount and is bolted.

Shot of the drivers rear...the second bar to the rear of the truck was added in addition to the Confer bar we started with...the plate for this bar is bolted directly onto the 3x3 angle under it and directly next to the 2x2 verticle body tube.

Shot of the passenger rear showing the double bar, the fitment of my air tank, and the spreader bar between the hoops...my shoulder harness connects to this, plus the height is such that it keeps my storage crates in place.

Photo two of the passenger rear....

Photo two of the main front cage setup...